Setting Up Your Recon - TDS Recon Getting Started Manual

Setting up your Recon

1. Attach the PowerBoot
The PowerBoot Module
Recon is shipped unattached. To attach
the PowerBoot, turn the latches counter-
clockwise until they are parallel to the
stylus holder, with the arrows pointing
towards the communication ports located
at the bottom of the PowerBoot.
2. Attach the hand strap
To connect the hand strap to your
Recon, hold the hand strap clip at a 45
degree angle and push the clip onto the
Recon bracket. Repeat the process with
the other end of the hand strap.
3. Charge your Recon
Connect the AC adapter to the
external power port on your
Recon. Charge for at least 12 hours
before using. For best results, turn
the Recon off while charging.
for your
TM
Firmly slide the PowerBoot onto the main
unit as shown. Pressure should be applied
downward and forward as the PowerBoot is
positioned.
Use the stylus to lock the PowerBoot
latches, by turning them clockwise one half
turn until they are pointed away from the
communication ports.
3