Table of Contents
Advertisement
The SerVision IVG-400 is a mobile DVR that is designed to be installed in
vehicles. Up to four cameras, six input sensors, and two activators can be
connected to the IVG-400. Once connected, these devices can be monitored and
controlled remotely through the IVG-400.
This document explains how to install the IVG-400 in a vehicle.
The following diagram indicates where the various connectors are located on the
IVG-400 unit.
Figure 1 - Connection diagram
The following hardware is included with the IVG-400:
1.
Two side supports
2.
Six screws to attach the side supports to the unit
Introduction
Connection Diagram
Hardware Requirements
IVG-400 Installation Instructions
Page 1 of 7
Advertisement
Table of Contents
