Vox; Room Monitor - Uniden uh710sx Owner's Manual

Uhf cb radio
Hide thumbs Also See for uh710sx:
Table of Contents

Advertisement

UNIDEN Model uh710sx/uh720sx UHF CB Radio
OPERATION

VOX

VOX is the automatic transmitting function by inputting voice into the VOX
headset mic without pressing the PTT key.
While headset microphone is not connected, VOX function is inactive even if
vox level setting is from 1 to 4.
VOX blinks while VOX function is active.
ENT
1.
Press
MENU
The current vox setting
flashes.
2.
Press
desired setting.
The 5 VOX levels are from
1 (High sensitivity) to 4
(Low sensitivity) and Off.
3.
Press and hold
and exit.

Room Monitor

The Room Monitor function sets the radio to operate as a transmitter only -
receive (speaker) is disabled.
The TX is activated by voice activation (VOX) without pressing
activate when the detected voice/noise volume exceeds the set threshold.
If the voice/noise keeps TX open for over 4 seconds then TX will continue
automatically for an additional 15 seconds. TX will finish when voice/noise
volume falls below the set threshold for 15 seconds.
While in Room Monitor mode;
The receive function is disabled.
RM flashes on the display.
Dual Watch function, if ON, is disabled.
Duplex mode is disabled on duplex channels.
Scan mode is disabled.
All key touch tones are disabled.
five times.
or
to select
ENT
to save
MENU
21
. TX will

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Uh710sx-2Uh720sxUh720sx-2

Table of Contents