Related Manuals for Uniden UH506SX-2NB
Summary of Contents for Uniden UH506SX-2NB
- Page 1 UH506SX-2NB UHF CB Radio For more exciting new products please visit our website: Australia: www.uniden.com.au New Zealand: www.uniden.co.nz...
-
Page 2: Controls And Indicators
Controls & Indicators Included in your Package • Charging Cradle with AC Adaptor • UH506SX-2NB Radio (2) • NiMH Battery Pack (2) • Owner’s Manual • Carabiner Clip (2) • Belt Clip (2) Optional Accessories • Speaker MIC • VOX Headset... -
Page 3: Getting Started
Rain or Moisture. NOTE Battery Installation Your UH506SX-2NB unit uses the included NiMH battery pack for power. The unit can be powered with optional 3 AAA ALKALINE batteries*. *The TX power is always low for alkaline batteries. - Page 4 Place the UH506SX-2NB into the charge cradle. The charge light will come on to indicate the unit is charging. Before operating the UH506SX-2NB, charge the battery pack for 16 hours. Do not charge alkaline or non rechargeable batteries. NOTE...
-
Page 5: Using The Carabiner Clip
To remove the belt clip, slightly lift the belt clip locker and slide the belt clip at the same time until released. Using the Carabiner Clip Use the carabiner clip to conveniently secure the UH506SX-2NB to a belt or strap. Low Battery Alert If the battery level becomes low, the battery indicator icon on the display begins flashing. -
Page 6: Operation
1.5 secs until it beeps to activate Key Lock. The appears. To unlock the keypad, press and hold (hi/lo/lock) again for 1.5 Secs. The disappears. While in Keylock on mode, the UH506SX-2NB can still receive and transmit. NOTE UNIDEN UH506SX-2NB... -
Page 7: Selecting A Channel
(Channels 22 and 23 are for telemetry and telecommand applications, channels 61,62 and 63 are for future use. TX is inhibited on these channels.) menu The maximum RF transmit power of UH506SX-2NB is 0.7W. hi/lo lock Before you transmit, listen for activity on the selected channel. -
Page 8: Open Scan (Os) Mode
(CALL/MON) Scanning The UH506SX-2NB has two types of scanning; Open Scanning (OS) and Group Scanning (GS), OS Scan searches all the channels and frequencies in its memory continuously. GS Scan is similar to OS scan but has the added ability to monitor the priority channel every 1.5 seconds. -
Page 9: Priority Channel Watch During Group Scan
To deactivate GS scanning, press (PTT) or press and hold vol (scan). 1. If SCAN is deactivated while it is tuned to an active channel, the UH506SX-2NB will stay on that active channel. If none of the channels re-active, the radio will reinstate the Scan start channel. -
Page 10: To Operate In Duplex Mode (Repeaters)
CTCSS is a feature that allows a group to talk to each other without hearing other users on the same channel. Select desired channel. Press (menu) once. CTCSS setting flashes. Press (ch) or (vol) to change the selection. Press & hold (menu) to save and exit. UNIDEN UH506SX-2NB UHF CB Radio... -
Page 11: Busy Channel Lockout
CTCSS or DCS code. Press (menu) five times. BCL setting flashes. Press (ch) or (vol) change the setting on or off. Press & hold (menu) to save and exit. UNIDEN UH506SX-2NB UHF CB Radio... -
Page 12: Roger Beep
Operation Call Tone Your UH506SX-2NB radio is equipped with 5 selectable call tones that will be transmitted when CALL/MON is pressed. Press (menu) six times. CL setting flashes. Press (ch) or (vol) change the selection. The 5 call tones are CL 1 to CL 5. - Page 13 The above situations are not a fault of the radio but a symptom of mixed wideband and narrowband radios in current use. It is expected that as older wideband radios are phased out this issue will be eliminated. UNIDEN UH506SX-2NB UHF CB Radio...
-
Page 14: Warranty
Terms of Warranty: Uniden Aust/NZ warrants to the original retail purchaser only that the UH506SX-2NB Radio (“the Product”), will be free from defects in materials and craftsmanship for the duration of the warranty period, subject to the limitations and exclusions set out below. - Page 15 Product, together with satisfactory evidence of your original purchase (such as a legible copy of the sales docket) to Uniden at the addresses shown below. You should contact Uniden regarding any compensation that may be payable for your expenses incurred in making a warranty claim.
- Page 16 THANK YOU FOR BUYING A UNIDEN PRODUCT. © 2012 Uniden Australia Pty Limited. Uniden New Zealand Ltd. Printed in PRC. U01UT952ZZZ(0)