Advertisement

MOSQUITO MAGNET
O
O
PERATION
PERATION
US Patents: No. 6,145,243, No. 6,286,249
AU Patent No. 726575, NZ Patent No. 335035
MADE IN USA
PART NO. 1440-400/REV. D
Liberty
M
M
ANUAL
ANUAL
Your trap will
begin capturing
immediately, but
allow 4-6 weeks
to interrupt the
breeding cycle.
For Outdoor Use Only
®

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Liberty and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Mosquito Magnet Liberty

  • Page 1 PART NO. 1440-400/REV. D MOSQUITO MAGNET ® Liberty PERATION ANUAL PERATION ANUAL Your trap will begin capturing immediately, but allow 4-6 weeks to interrupt the breeding cycle. For Outdoor Use Only US Patents: No. 6,145,243, No. 6,286,249 AU Patent No. 726575, NZ Patent No. 335035...
  • Page 2: Table Of Contents

    (see trap placement section). The female, egg-laying, biting mosquitoes are drawn away from you and to the Mosquito Magnet, where they are vacuumed For Outdoor Use Only. If Stored Indoors, Detach and Leave Propane Cylinder Outdoors.
  • Page 3 The installation must conform with local codes or, in the absence of local codes, with the National The Mosquito Magnet shall be used outdoors only in a well ventilated space and shall not be used in a Fuel Gas Code, ANSI Z223.1-1998 for US and with the CAN1-B149 for Canada.
  • Page 4: Parts Included

    Per Federal Regulations, a CO2 Cartridge has not been “-20 Nyloc Nuts included with your purchase. Please visit Washers “ / www.mosquitomagnet.com or your local Mosquito Magnet dealer to purchase. TOOLS NEEDED INCHES 3/8” and 1/4” Open End Wrench Phillips Head screw driver Adjustable wrench 18 19...
  • Page 5: Assembly Instructions

    Add vaseline to tops of legs first. Using two Take black carbon dioxide Insert carbon dioxide tube into base. Attach nyloc nut (B3) hands, mount Liberty power head onto leg tube with slotted side up. trumpet. Align slots in tube with and tighten.
  • Page 6: Trap Placement

    Stand in the center of the area you are trying to protect and look toward the prevailing wind. Proper placement of the Mosquito Magnet will be 30-40 feet in front of you, within 5-6 feet of ground cover (i.e., bushes, flowerbeds, treeline, marshbed, etc.)
  • Page 7: Start-Up Instructions

    The Quick-Clear valve is used to clear out propane contaminants in the fuel line, which may block the flow of propane from the tank to your Mosquito Magnet. The Quick-Clear valve is a gold, threaded knob located on the back of your trap.
  • Page 8: Gas Reset Tool

    GAS RESET TOOL INSTRUCTIONS TROUBLESHOOTING GUIDE If your Mosquito Magnet fails to start, it may be the result of poor gas flow from the propane tank through the regulator to the trap. PROBLEM POSSIBLE CAUSES SOLUTIONS The attached tool has been designed to reset the internal mechanisms of the propane regulator and release any back pressure from your tank.
  • Page 9: Burying The Cord

    11. Would you consider giving a testimonial once you are thoroughly convinced of the effectiveness of the Mosquito Magnet? LIMITATIONS AND EXCLUSIONS: The warranty shall not apply to problems arising from normal wear, or failure to adhere to the enclosed instructions.

Table of Contents