Worx Sonicrafter WX680 Safety And Operating Manual
Worx sonicrafter oscillating tool safety and operating manual
Hide thumbs
Also See for Sonicrafter WX680:
- User manual (44 pages) ,
- Original instructions manual (157 pages) ,
- Manual (84 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Worx Sonicrafter WX680
Summary of Contents for Worx Sonicrafter WX680
- Page 1 SAFETY AND OPERATING MANUAL Oscillating Tool WX680...
- Page 3 Hyperlock Accessory Clamping Lever On/Off Switch Variable Speed Dial Constant Speed Electronics Venting Slots Universal Fit Accessory Interface * Flange Smaller Flange For other brands' sanding pads * Works with other oscillating tool brands' accessories. The following brands are trademarks owned by third parties which may be registered by their respective owners: Black &...
-
Page 6: Technical Data
TECHNICAL DATA Rated voltage 230-240V~50Hz Rated power 350W Oscillations speed 11000-20000 /min Oscillations angle 4.0° Protection class 1.3kg Tool weight (without power cable) Oscillating Tool WX680... -
Page 7: General Power Tool Safety Warnings
Use e) When operating a power tool of these devices can reduce dust-related outdoors, use an extension cord hazards. suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of Oscillating Tool WX680... - Page 8 5) SERVICE a) Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained. Oscillating Tool WX680...
- Page 9 Avoid danger of injury from the sharp edges of the accessories. Accessories can become very hot while working, presenting danger of burns! Make sure the tool is unplugged prior to changing accessories. Oscillating Tool WX680...
-
Page 10: Assembly And Operation
This is normal and will not damage your power tool. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. Oscillating Tool WX680... - Page 11 To ensure an even distribution, loosen the saw blade, rotate it and retighten firmly.Cut/Sand with a constant movement and light pressure. Heavy pressure does not increase the cut/removal rate – the accessory merely wears faster. Oscillating Tool WX680...
- Page 12 Copyright © 2014, Positec. All Rights Reserved. 2PGA91APK11002A1...