Whirlpool Oasis HE 2006 Manual page 7

LOCATION REQUIREMENTS
Selecting the proper location for your washer
improves performance and minimizes noise
and possible washer "walk."
The washer can be installed in a basement,
laundry room, closet, or recessed area. See
"Drain System."
IMPORTANT: Do not install or store the wash-
er where it will be exposed to the weather.
Proper installation is your responsibility.
You will need:
A water heater set to deliver 120°F (49°C)
water to the washer.
A grounded electrical outlet located with-
in 4 ft (1.2 m) of where the power cord is
attached to the back of the washer. See
"Electrical Requirements."
Hot and cold water faucets located within
3 ft (90 cm) of the hot and cold water fill
valves, and water pressure of 20-100 psi
(1 38-690 kPa) for best performance.
A level floor with a maximum slope of
l"(2.5 cm) under entire washer. Install-
ing the washer on carpeting is not recom-
mended.
A sturdy floor to support the washer
weight (washer, water and load) of 315 Ibs
(143 kgs).
Do not store or operate your washer in tem-
peratures at or below 32°F (0°C). Some wa-
ter can remain in the washer and can cause
damage in low temperatures.
INSTALLATION SPACING FOR RECESSED
AREA AND CLOSET INSTALLATIONS
The following spacing dimensions are rec-
ommended for this washer. This washer has
been tested for installation with spacing of 0"
(0 cm) clearance on the sides. Recommend-
ed spacing should be considered for the fol-
lowing reasons:
Additional spacing should be considered
for ease of installation and servicing.
Additional spacing should be considered
on all sides of the washer to reduce noise
transfer.
For closet installation with a door, minimum
ventilation openings in the top and bottom
of the door are required. Louvered doors
with equivalent ventilation openings are
acceptable.
Companion appliance spacing should also
be considered.
8
C
3,
. F rmf
*.@*
3.
sue
3':e#
12.
ctei
&car
w.*+
L t B 5 Y 9
* Required
spacing