Whirlpool Oasis HE 2006 Manual page 24

AUTO TEMP COYTROL
AutoTemp Control (ATC) electronically senses
and maintains a uniform wash and rinse water
temperature. ATC regulates incoming hot and
cold water. The ATC is automatically turned On
when a cycle is selected. (See "Preset Cycle
Settings" in "Cycles.")
ATC is available with WarmNVarm, WarmICold
and CoolICold settings. The water temperature
in the ColdICold setting depends on the water
temperature at the water inlet faucets.
ATC ensures consistent cleaning.
Heated water consumes the largest amount
of energy that a washer uses.
Today's detergents workwell at temperatures
above 60°F (1 56°C).
DELAY START
You can use the Delay Start feature to delay
the start of a wash cycle for up to 13 hours
(depending on the model).
1. Load the washer and fill the dispensers.
2.
Close the washer lid.
3.
Press POWER.
4.
Select the desired Cycle, Modifiers, and
Options.
5. Press DELAY START. 1 H (one hour)will be
displayed in the time display window. The
indicator light for Delay Start will flash.
6.
For a longer delay time, press Delay Start.
The Start time will increase by I-hour
steps.
7. Press START. The countdown to the wash
cycle will show in the time display window
and the Delay Start indicator light will
glow.
NOTE: You must press Start to initiate a
countdown for the cycle to begin.
To change the Delay Start time:
Press STOP.
Press DELAY START to select the desired
delay time.
Press START to begin the countdown.
To cancel Delay Start:
Press START again to begin the cycle right
away, or press STOP twice to cancel the
cycle.
OPTIONS
Use these pads to select the desired options
for the wash cycle.
SAVE ENERGY PLUS
The Save Energy Plus option reduces wash
and rinse water temperatures to save energy
while adding about 5 minutes of wash time to
maintain performance. This option must be
selected prior to the start of the cycle. The
Save Energy Plus option is only available in
the Heavy Duty and Whitest Whites cycles.
2ND RINSE
A 2nd rinse can be used to aid in the removal
of detergent or bleach residue from garments.
This option provides an additional rinse with
the same water temperature as the first rinse.
This is the default rinse setting for the Whitest
Whites cycle. Fabric softener will be dispensed
during the 2nd Rinse.