Whirlpool Oasis HE 2006 Manual page 50

To check FABRIC SOFTENER valve select
or press the following:
NORMAL START (turns on Fabric
Softener valve, cycle indicator flashes)
WASHIRINSE TEMP (enables fill of Hot,
Warm, Cold or no water according to
WASHIRINSE TEMP selection and indi-
cator) START (turns off Fabric Softener
valve, cycle indicator is steady on).
To check BLEACH valve select or press the
following:
CASUALNVRINKLE FREE START
(turns on Bleach valve, cycle indicator
flashes) WASHIRINSE TEMP (enables
fill of Hot, Warm, Cold or no water ac-
cording to WASHIRINSE TEMP selection
and indicator) START (turns off Bleach
valve, cycle indicator is steady on).
NOTE: Washer can only fill cold through
Bleach valve.
If any valve fails to turn on go to TEST #2.
Manual: Pumps
.
....
--.
P m
3 r d ~ q m . T g m c n
mj~Lld*m
DUW,
indvdm
8
$ ! E.@,l '$#A$
e f 4
$&3f Sf
W I .
Rswt
- +
T u n ~ E m n A a ~ k o p u ~ . indkatcctrmaif.
R e w
T!!TS
13-1
&'XZ&X
~~~.
-+
T u ~ iii m n
rum?,
fi*~*x
! l m
#.
If pumps fail to turn on go to TEST #7.
Manual: Door Switch
Opening the door should cause the Clothes
Clean status indicator to turn off. Closing the
door should cause the Clothes Clean status
indicator to turn on.
If Clothes Clean indicator does not turn off
or on, go to TEST #8.
Manual: Door Lid Lock
NOTE: Door must be closed. If door is not
closed, an invalid button press beep will oc-
cur when performing next step.
Manual: Motor
Rotor Position Sensor (RPS): Uses Wash,
Rinse and Spin indicators to detect the three
hall sensors. Console may have up to two of
these indicators on at one time when the bas-
ket is not moving. Open door and rotate bas-
ket by hand. The Wash, Rinse and Spin status
indicators should toggle on and off according
to direction the basket is being turned.
If none of these indicators are on go to
TEST #3.
Spin: To activate Spin, door must be closed
with door lock enabled. See Manual: Door Lid
Lock.
NOTE: If door is not closed, an invalid button
press beep will occur when performing next
step.
NOTE: Indicators above button scroll from
top to bottom.
If motor fails to spin, go to TEST #3.
Agitate: Water must cover the wash plate (or
agitator vanes) to ensure the basket is float-
ing prior to agitation. Enabling agitation with-
out enough water may cause a fault condition
to occur. See Manual: Water Valves.
NOTE: lndicators above button scroll from
top to bottom.
If motor fails to agitate, go to TEST #3.
If door does not lock or unlock, go to TEST
#8.