Whirlpool Oasis HE 2006 Manual page 51

ACTIVATING THE AUTOMATIC
DIAGNOSTIC TEST MODE
1. Be sure the washer is in standby mode
(plugged in with all indicators off, or with
only the Clothes Clean indicator on).
2.
Select any one button (except POWER,
START, and STOP) and follow the steps
below, using the same button (remember
the button):
FCcs~h-34 .+R&ah Fm&idd , P k a k i +
Pm4;kdd
$%iw& 4 w a & * 2 . ; : & 2-ia Z w m Q
If this test mode has been entered suc-
cessfully, all indicators on the console
are illuminated for 5 seconds with 88
showing in the Estimated Time Re-
maining two-digit display.
If indicators do not display as de-
scribed above, the press/hold/release
procedure above may not have been
performed within the time frame neces-
sary for successful entry. Repeat step
2 to ensure this was not the cause. If
still unsuccessful, see Diagnostic: Un-
successful Entry.
3. The program then checks for saved fault
codes:
If there are saved fault codes, see Di-
agnostic: Saved Fault Codes.
If there are no saved fault codes, all
indicators on the console will momen-
tarily turn off, then turn back on with 88
displayed. After 5 seconds, the Auto-
matic test, below, begins.
DIAGNOSTIC: Automatic
Performs a four-minute automatic test with
water functions to check major washer func-
tions (door can be open). Press the same but-
ton used in step 2 above to advance through
automatic test steps.
DIAGNOSTIC: Unsuccessful Entry
If entry into diagnostic mode is unsuccessful
(see steps 1 and 2 of Activating the Automatic
Diagnostic Test Mode), refer to the following
indications and actions: