Setting The Clock - Teac SL-D900BT Owner's Manual

Set the current time before using the unit.
1
Press the STANDBY/ON button to put the
unit into standby.
2
Press and hold the CLOCK ADJUST button
for at least two seconds.
3
Press the skip/search (.m/,/)
buttons to switch between "24H" (24-hour)
and "12H" (12-hour) time display.
c3

Setting the clock

4
Press the CLOCK ADJUST button.
The "hour" value blinks.
5
Use the skip/search (. m /, / )
buttons to set the hour.
6
Press the CLOCK ADJUST button.
The minute value blinks.
7
Use the skip/search (. m /, / )
buttons to set the minute.
8
Press the CLOCK ADJUST button.
This completes the procedures for setting the time.
The clock will start from the set minute at 0 seconds.
o The unit's current time data will be erased if the power
supply is interrupted for about 10 minutes because
a power outage occurs or the power plug is discon-
nected from an outlet.
15