Panasonic CQ-VD5005U Operating Instructions Manual page 58

Installation
❏ Final Checks
1. Make sure that all wires are properly connected
7
and insulated.
2. Make sure that the LCD monitor is securely held in
the mounting collar.
3. Turn on the ignition to check the unit for proper
operation.
If you have difficulties, consult your nearest authorized
professional installer for assistance.
❏ Precautions
Caution
¡We strongly recommend that you wear gloves for
installation work to protect yourself from injuries.
¡When bending the mounting tab of the mounting
collar with a screwdriver, be careful not to injure
your hands and fingers.
¡Disconnect the cable from the negative (–) battery ter-
minal (see caution at right).
¡Unit should be installed in a horizontal position with
the front end up at a convenient angle, but less than
30°.
Warning
¡If your car is equipped with air bag and/or anti-
theft systems, specific procedures may be
required for connection and disconnection of the
battery to install this product.
Before attempting installation of this electronic
component against the manufacturer's recom-
mendation, you must contact your car dealer or
manufacturer to determine the required proce-
dure and strictly follow their instructions.
FAILURE TO FOLLOW THE PROCEDURE MAY
RESULT IN THE UNINTENDED DEPLOYMENT OF
AIR BAGS OR ACTIVATION OF THE ANTI-THEFT
SYSTEM RESULTING IN DAMAGE TO THE VEHI-
CLE AND PERSONAL INJURY OR DEATH.
0 – 30°
8
CQ-VD5005U/L
(continued)
¡ Various settings that have been stored in the
This unit should be professionally installed. In case of
difficulty, please consult with your nearest professional
installer.
1. This unit only operates in a 12 V DC negative ground
system.
2. Follow the Electrical Connections carefully
14-19). Failure to do so may result in damage to the
unit.
3. Connect the power lead after all other connections are
made.
4. Be sure to connect the battery lead (yellow) to the pos-
itive terminal (+) of the battery or fuse block (BAT) ter-
minal.
5. Insulate all exposed wires to prevent short circuiting.
6. Secure all loose wires after installing the unit.
7. Please carefully read the operating and installation
instructions of the respective equipment before con-
necting it to this unit.
¡Please follow the laws and regulations of your
Caution
memory in other on-board equipment (car naviga-
tion etc.) may be lost if the battery terminals are
disconnected.
Therefore, we recommend you to make a record
of or to back up the settings before disconnecting
the terminals.
After completing installation of the main unit, set
up the equipment again according to the settings.
Caution
state, province or country for installation of the
unit.
(a page