Channel Selection; Tv Tuner Control - Panasonic CQ-VD5005U Operating Instructions Manual

TV Tuner Control

Preparation:
¡ Connect a TV tuner (CY-TUN153U, option) to the
unit.
TV
¡ Select with use of "AV2 Input Selection".
(a page 35)
27
Source Selection
q Touch "Source Button".
d
Press [SOURCE] to change to the TV
mode.
To switch Operation Screen ON, touch the center of
touch panel.
Note:
¡CY-TUN153U is an analog TV-specific tuner.
¡If the analog broadcast system is replaced with the dig-
ital broadcast system in a country or area where CY-
TUN153U is used, TV broadcasts cannot be received.
¡Inquire about the termination of analog broadcasting to
the authorities concerned in the country or area where
Tuning
Operations
Band Selection
Channel
Selection
Channel Seeking
Displaying TV
Menu
Selecting an Item
on the TV Menu
...... Touch/Press and hold
28
CQ-VD5005U/L
w Touch
(TV)
on the Source
Selection Screen.
(Content varies with
connected devices)
¡For the operations of the TV tuner with its remote con-
¡The remote control of the TV tuner ( CY-TUN153U ,
–
END
DVD VTR
RADIO CH-C
TV 1 TV 2
[d]
[s]
[d]
[s]
–
–
¡It is required to install the TV antenna to receive TV
broadcasts.
¡For receiving TV broadcasts, stop your car where
there is no obstacle to broadcast reception around.
Source Button
DIMMER
IN-DASH 7" WIDESCREEN COLOR LCD MONITOR / DVD RECEIVER
CQ-VD5005U
DIMMER DIM
CQ-VD5005W
VOL TUNE/TRACK
POWER
SEL
PUSH MUTE SETUP
SOURCE SOURCE
[SOURCE]
[s] [d]
CY-TUN153U is used.
trol, aim the remote control at the remote control sen-
sor of this unit.
option) cannot turn on or off the power of the TV tuner.
Up
Down
Up
Down
Calls up the menu of the tuner.
To cancel, touch again.
Left/right
Up/down
TILT CLOSE

Channel selection/

Channel seeking
TV menu
Preset channel
selection
TEXT
TILT
OPEN
Band selection
AV1 IN