GE Interlogix 0150-0265A User Manual page 12

GE Interlogix
Source
Camera number
Pan information
Tilt information
Zoom information
Checksum
4.1.3.2 I
RIS AND
There is a motor start and motor stop command associated with each of the 4
functions to be controlled: Iris Open, Iris Close, Focus Near, Focus Far. A
message is generated each time one of these four keys are pressed or released.
The ProBridge Gateway converts these messages to 312 messages as follows:
Port 0: Example with Iris Close (Start) on WaveReader
Motor Message format:
Synchronization
Length
Message type 1
Message type 2
Destination
Source
Camera number
Motor command
Checksum
Port 1: Iris, Focus message at KTD405
Message format:
Synchronization
Length
Message type 1
Message type 2
Destination
Source
Camera number
"Monitor " value
Checksum
4.1.3.3 M T
OUSE
Mapped address only. Nothing else has been changed.
4.1.3.4 A :
UX
Not available at this time.
12
0x00-0xFD keypad address <= Impac Mux/DVMRe
Mapped camera: 32 Cameras/Zone
0x00: No Pan movement; 0x01 to 0x20: Pan Left at speed 1
to 32...
0x00: No Tilt movement; 0x01 to 0x20: Tilt Down at speed to
32...
0x00: No Zoom; 0x80+(0x01 to 0x20): Zoom In at speed 1 to
32...
2's complement
F
(No Speed Values)
OCUS
0xFF
0x07
0x09
0x05
Impac Mux/DVMRe
Impac Mux/DVMRe
Camera connected to Mux/DVMRe (00-0F)
Iris Close Start (Impac motor command)
2's complement
0xFF
0x07
0x20 Digiplex message
312 command code
CMD312_IRIS_CLOSE(C) (Start)
Mapped camera: 0x80-0xFD* 0x80 + camera # high byte
0x00-0xFD keypad address <= Impac Mux/DVMRe
Mapped camera: Camera (site) # low byte
0 (General command parameter)
2's complement
C :
RAK OMMAND
ProBridge Gateway
0150-0265A / August 2003