Ins8250 Functional Pin Description; Input Signals - IBM 5150 Hardware Reference Manual

INS8250 Functional Pin Description
The following describes the function of all INS8250 input/output pins.
Some of these descriptions reference internal circuits.
Note: In the following descriptions, a low represents a logic 0 (0 volt
,.-......, nominal) and a high represents a logic 1 (+2.4 volts nominal).
Input Signals
Chip Select (SCO, CS1, CS2), Pins
12-14:
When CSO and CSI are high
and CS2 is low, the chip is selected. Chip selection is complete when
the decoded chip select signal is latched with an active (low) Address
Strobe (ADS) input. This enable comunication between the INS8250
and the CPU.
Data Input Strobe (DISTRDISTR) Pins 22 and 21: When DISTR is
high or DISTR is low while the chip is selected, allows the CPU to read
status information or data from a selected register of the INS8250.
Note: Only an active DISTR or DISTR input is required to transfer
data from the INS8250 during a read operation. Therefore, tie either
the DISTR input permanently low or the DISTR input permanently
high, if not used.
,.-......, Data Output Strobe (DOSTR, DOSTR), Pins 19 and 18: When
DOSTR is high or DOSTR is low while the chip is selected, allows the
CPU to write data or control words into a selected register of the
INS8250.
Note: Only an active DOSTR or DOSTR input is required to transfer
data to the INS8250 during a write operation. Therefore, tie either the
DPSTR input permanently low or the DOSTR input permanently high,
if not used.
Address Strobe (ADS), Pin 25: When low, provides latching for the
Register Select (AO, AI, A2) and Chip Select (SOC, CSl, CS2)
signals.
Note: An active ADS input is required when the Register Select
(AO, AI, A2) signals are not stable for the duration of a read or write
operation. If not required, the ADS input permanently low.
2-129