Cassette User Interface; Cassette Jumpers; Circuit Block Diagrams; Cassette Interface Read Hardware - IBM 5150 Hardware Reference Manual

Cassette User Interface
The cassette interface control is implemented in software. (See FIRM­
WARE Section). An 825 3 timer output is used to control the data to the
cassette recorder. This output exits the System Board, at the rear,
through pin 5 of a DIN connector. The cassette input data is read by
an 8255A-5 Programmable Peripheral Interface (PPI) input port bit.
This signal is received through pin 4 of the cassette connector. Software
algorithms are used to generate and read cassette data. The casette
drive motor is controlled through pins 1 & 3 of the cassette connector.
The motor on/off is controlled by an 8255A-PPI output port bit.
(Port '61 H', bit 3). The 8255 A address and bit assignments are defined
in the I/O Address Map page. On the following pages are read, write,
and motor control block diagrams.
Cassette Jumpers
A 2x2 Berg Pin and Jumper are used on the cassette Data Out line.
The jumper will allow the Data Out line to be used as a microphone
input (75 mv.) when the jumper is placed across M and C pins. An
auxiliary input is available when the jumper is placed across the A and
C pins. The auxiliary input provides a .68 volt input to the recorder.
Refer to System Board Component Diagram page (2-13) for cassette
jumper location.
M A M A
JUMPER DIAGRAM
Mike· 75 Mv.
Aux·O.68V
Circuit Block Diagrams
GND
+5V
CASSETTE
DATA IN
SILICON
GND
DIODE
RECORDER
VIR=,4V
CATHODE
EARPHONE
JACK
GND
Figure 7. CASSETTE INTERFACE READ HARDWARE
2-19