Summary Of Available Colors; Programming Considerations; Programming The 6845 Controller - IBM 5150 Hardware Reference Manual

Table 5.
Summary of Available Colors
R
G B
COLOR
0 0 0 0
Black
0 0 0 1
Blue
0 0 1 0
Green
0 0 1 1
Cyan
0 1 0 0
Red
0 1 0 1
Magenta
0 1 1 0
Brown
0 1 1 1
Light Gray
1 0 0 0
Dark Gray
1 0 0 1
Light Blue
1 0 1 0
Light Green
1 0 1 1
Light Cyan
1 1 0 0
Light Red
1 1 0 1
Light Magenta
1 1 1 0 Yellow
1 1 1 1 White
I
Note: "I" provides extra luminance (brightness) to each shade
available. Resulting in the light colors listed above, except
1"' " """"\
where the "I" bit is not recognized by some monitors.
Programming Considerations
Programming the 6845 CRT Controller
The 6845 has 19 internal registers which are used to define and control
a raster scanned CRT display. One of these registers, the Address
Register, is actually used as a pointer to the other 18 registers. It is a
write only register which is loaded from the CPU by executing an OUT
instruction to I/O address 3D4. The five least significant bits ofthe I/O
bus are loaded into the Address Register.
In order to load any of the other 18 registers, the Address Register is
first loaded with the necessary pointer and then the CPU may output a
value to I/O address 3D5 in order to load the information in the
preselected register.
The following table defines the values which must be loaded in 6845
1"' " """"\ Registers in order to control the different modes ofoperation supported
by the attachment.
2-55