Panel Features And Cabling; Ethernet/Lan Communication; Power - Extron electronics IPL M PDP-ES User Manual

im Vertrieb von
Installation and Operation, cont'd
Push gently
Figure 2-3 — Inserting the IPL M PDP-ES card into
the communication slot
Be very careful when inserting the card. Do not
CAUTION
use excessive force, and push the card in as straight
as possible; a crooked entry could damage the card
or the plasma.
2. When the card is seated securely in the slot, use the spring
loaded thumb screws on either end of the card faceplate to
secure the card in place.
Thumb screws
Figure 2-4 — Securing the IPL M PDP-ES
3. Affix the Extron IPL M PDP-ES sticker label (Extron part #
33-1154-01) to the display, covering the existing Pioneer
label, as shown below.
Insure that the sticker is placed so that it completely
covers the existing Pioneer label.
Figure 2-5 — The IPL M PDP-ES sticker label
www.camboard.de
2-4 IPL M PDP-ES • Installation and Operation
CAMBOARD Electronics

Panel Features and Cabling

Ethernet/LAN communication

Power

Tel. 07131 911201
Fax 07131 911203
See figure 2-6 below for detailed information about connections,
LEDs, and power.
RS-232
RESET
ACT LINK
IPL M PDP-ES
LAN
6
1 2 3 4 5
Figure 2-6 — IPL M PDP-ES interface card
With the use of Ethernet/LAN communication, the
IPL M PDP-ES can be used to control the plasma display. See
chapter 4, Communication and Control, for more details.
LAN Activity LED — The yellow LED blinks to indicate
1
LAN activity.
LAN connector — Plug an RJ-45 jack into this socket to
2
connect the unit to a computer network. Use a straight-
through cable to connect to a switch, hub, or router; and a
crossover cable to connect directly to a PC.
LAN Link LED — The green LED lights to indicate a good
3
LAN connection.
Clip Down
1 2 3 4 5 6 7 8
RJ-45
Straight-through cable
connector
Side 1 Side 2
Pin Wire color Pin Wire color
1 White-orange 1 White-orange
2 Orange 2 Orange
3 White-green 3 White-green
1 2 3 4 5 6 7 8
4 Blue 4 Blue
5 White-blue 5 White-blue
6 Green 6 Green
7 White-brown 7 White-brown
Twisted
Pairs
8 Brown 8 Brown
7&8
1&2 3&6 4&5
Figure 2-7 — RJ-45 connector wiring
For best performance, use a shielded Ethernet cable.
On/Off indicator LED — The green LED lights to indicate
4
that the card is receiving power. It also indicates different
reset modes.
ce-info@camboard.de
IPL M PDP-ES • Installation and Operation
Crossover cable
Side 1 Side 2
Pin Wire color Pin Wire color
1 White-orange 1 White-green
2 Orange 2 Green
3 White-green 3 White-orange
4 Blue 4 Blue
5 White-blue 5 White-blue
6 Green 6 Orange
7 White-brown 7 White-brown
8 Brown 8 Brown
2-5