Ipl M Pdp-Es Interface Card Configuration; Configuring The Ipl M Pdp-Es Using The Arp Command - Extron electronics IPL M PDP-ES User Manual

im Vertrieb von
Connection and Configuration, cont'd
IPL M PDP-ES card for DHCP (Dynamic Host Configuration
protocol) to have an address assigned automatically.

IPL M PDP-ES interface card configuration

When you connect with the IPL M PDP-ES card for the first
time, there are three ways to set up the IP address:
1. Use the ARP command method.
2. Use the direct PC method.
3. Use SIS commands through the RS-232 port.
Once the IPL M PDP-ES has an IP address assigned and on an
active network, the on-board default Web pages allow you to
configure the interface card.

Configuring the IPL M PDP-ES using the ARP command

You can make use of the ARP (Address Resolution Protocol)
command to set up an IP address for your IPL M PDP-ES. The
ARP command tells your computer to associate the
interface card's MAC address with the assigned IP address. You
must then use ping to access the IPL M PDP-ES unit, at which
point the device server's IP address is reconfigured.
In order for you to use this setup method, both your
computer and the IPL M PDP-ES interface card must be
connected to the same LAN. Ensure that your PC is on
the same subnet mask as the IPL M PDP-ES card.
Use ARP to configure the IP address as follows:
1. Obtain a valid IP address for your IPL M PDP-ES card
from your network administrator.
2. Obtain the IPL M PDP-ES card's MAC address (UID #)
from the label on its face panel.
3. If the interface card has never been configured and is still
set for factory defaults, go to step 4. If it has been
configured previously, perform a mode 4 system reset.
For detailed information on reset modes, see Resetting the
unit in chapter 2.
CAUTION
Your IPL M PDP-ES card must be configured with
the factory default IP address — 192.168.254.254
—before you execute the ARP command, as
described below.
4. Access the MS-DOS command prompt, then execute the
arp –s command as follows:
www.camboard.de
3-4 IPL M PDP-ES • Connection and Configuration
CAMBOARD Electronics
Tel. 07131 911201
Fax 07131 911203
Enter the desired new IP address and the MAC address
(located on the face panel) for the interface card. For
example:
arp –s 10.13.170.15 00-05-A6-00-0A-90
Figure 3-3 — Executing the ARP command
5. Execute a ping command by entering your new IP
address at the command prompt. For example:
ping 10.13.170.15
After you issue this command, the unit changes to the new
address and starts responding to the ping requests, as
shown below. The interface card's IP address should now
be updated to the new address. You can now reconnect
using either Telnet or the Web to verify that the update
was successful.
Figure 3-4 — Unit response to a ping request
ce-info@camboard.de
IPL M PDP-ES • Connection and Configuration 3-5