Cisco 12000 Series Replacement Instructions Manual page 31

Figure 17
Gently press the SODIMM down using your index fingers, distributing even pressure across the module
Step 9
until it locks into the tabs. (See
Excessive pressure can damage a SODIMM socket.
Caution
Verify that the release levers are flush against the side of the socket. If they are not, the SODIMM might
Step 10
not be seated properly.
If the module appears misaligned, carefully remove it and reseat it, ensuring that the release lever is flush
Step 11
against the side of the SODIMM socket.
Insert the retainer clip by sliding the clip between the metal strain relief and the latch.
Step 12
(See Figure
78-4338-16
Installing a SODIMM
a
Figure
18.)
45 º
17b.)
Cisco 12000 Series Router Memory Replacement Instructions
Removing and Installing Line Card Memory
b
31