Korg M1 Owner's Manual page 55

INSERT FX
☞ M1 owner's manual PDF, page 36 "3 - Effect parameters"
IFX ....................................................................... [OFF, ON]
This switch acts as a bypass, turning the entire insert effect
section on/off. This setting is linked with the Timbre Param-
eter "IFX."
OFF (dark): The insert effects will not be heard (bypassed).
ON (lit): The insert effects will be heard (active).
ROUTING TYPE ........................................[SERIAL, PARALLEL]
Selects the routing of the insert effects.
The Routing Type can only be selected when the "OSC
MODE" (☞p.38) is set to DRUMS. In this case, there
are two stereo buses available. When the "OSC
MODE" is set to SINGLE or DOUBLE, one stereo bus
is available, the Routing Type is set to Serial, and PAN
controls are inserted between FX1 and FX2.
FX 1/FX 2 ............................................................ [OFF, ON]
Switches the individual insert effects on/off.
PAN ON/OFF ....................................................... [OFF, ON]
Switches the pan on/off.
If this setting is OFF, the signals will not be send.
If you've turned PAN off in DRUM mode and then
change the OSC MODE to SINGLE or DOUBLE, you
will need to turn the PAN controls on again in order to
hear any sound.
PAN ......................................................... [L50...C00...R50]
Specifies the panning of A and B when the "OSC MODE" is
set to SINGLE or DOUBLE.
Specifies the panning of C and D when the "OSC MODE" is
set to DRUMS.
OUT .......................................................... [–, 1+2...15+16]
Selects the output destination for each timbre. This is linked
with the timbre parameter "OUT." (☞ "OUT" on page 24)
FX 1/FX 2
EFFECT TYPE................... [No Effect, Reverb...Delay/Tremolo]
Selects the effect type.
Effect Parameter
Here you can set the parameters of the effect selected in
"EFFECT TYPE." For the effects that were added in the M1
software synthesizer, refer to "Effect Parameters" on page 32.
For the parameters of the other effects, refer to the original
M1 owner's manual.
☞ M1 owner's manual PDF, page 36 "3 - Effect parameters"
Using MIDI control change messages to control the
speed of the Rotary Speaker
Refer to "Using MIDI control change messages to control the
speed of the Rotary Speaker" on page 33.
Transmitting CC#76 (Vibrato Rate) with a value of 127 from
your external MIDI device on the Global MIDI Channel (☞
"MIDI Ch" on page 30) will switch the rotary speed to Fast;
transmitting a value of 000 will switch to the Slow speed.
Combination mode
51