Korg M1 Owner's Manual page 36

Parameters of each mode
MASTER FX
ROUTING TYPE ....................................... [SERIAL, PARALLEL]
Selects the effect routing.
FX 1/FX 2 ............................................................[OFF, ON]
Switches the effect on/off.
PAN ON/OFF........................................................[OFF, ON]
Switches the pan on/off.
If this setting is OFF, the signals will not be send.
PAN.......................................................... [L50...C00...R50]
Specifies the panning of IN 3 and IN 4.
In the stand-alone version, the sound of that timbre
will not be output if you set the timbre output (☞
"OUT" on page 24) to a setting other than 1+2 or 3+4.
FX 1/FX 2
EFFECT TYPE................... [No Effect, Reverb...Delay/Tremolo]
Selects the effect type.
Effect Parameters
Here you can edit the parameters of the effect selected by
"EFFECT TYPE." For details on the parameters available for
each effect, refer to the PDF of the original M1 owner's man-
ual.
☞ M1 owner's manual PDF, page 36 "3 - Effect parameters"
32
The M1 software synthesizer adds one new effect, a "Com-
pressor." The compressor's parameters are shown in the dia-
gram to the right.
Compressor
This effect compresses the input signal, making it more con-
sistent. It is particularly good when applied to instruments
such as guitar, piano, and drums.
Left
Envelope - Control
Envelope - Control
Right
ATTACK..........................................................[000...500ms]
Adjusts the strength of the attack.
SENSITIVITY ........................................................... [00...99]
Adjusts the sensitivity of the compressor.
OUT LEVEL ......................................................... [000...100]
Adjusts the output level of the compressor.
EQ TRIM............................................................. [000...100]
Adjusts the input level to the compressor.
WET / DRY
Compressor
OUT LEVEL
OUT LEVEL
Compressor
WET / DRY