Table of Contents
Advertisement
LED INDICATOR
LED indicator
Red and blue LED flashes alternately
Blue LED flashes once every two seconds
Blue LED flashes twice every four seconds
Red LED flashes instead of blue LED
FACTORY RESET
To reset the earphones back into the default factory settings, press
seconds and release it until the red and blue LED's flash simultaneously, and you hear four
prompt tones.
NOTE: After factory reset, the paired list of devices will be deleted. After it is turned on again,
the earphones will enter pairing mode automatically, and you need to re-pair and re-connect
with Bluetooth devices.
CARE AND MAINTENANCE
Read the following recommendations carefully before using EP-SB. Following these guidelines,
you will be able to enjoy your earphones for many years.
1.
Please use the cord management clips to avoid cable strain.
2.
Although your earphones are rain and sweat proof, to help longevity when not in use,
keep earphones dry and don't put them in a damp place to avoid the product's internal
circuits from getting wet.
3.
Keep the product away from direct sunlight or hot places. High temperatures will shorten
the life of electronic devices, destroy the battery or distort certain plastic parts.
4.
Don't expose the product to extremely cold areas. It may damage the internal
circuit board.
5.
Don't try to disassemble the product; it may get damaged if you are not professional.
6.
Don't let it fall down onto the floor or other hard surfaces. The internal circuits
might get damaged.
EP-SB Bluetooth Stereo Earphones
Status of Earphones
Pairing mode
Not connected to a device
Connected to a device
Low battery
13
button for about four
User's Manual
Advertisement
Table of Contents
