Installation - Haier HW-F1481 ME User Manual

06

INSTALLATION

ADJUSTING THE BOTTOM COVER
Before removing the transportation bolts, please fi x the bottom cover
to the bottom of the washing machine. Lay down the machine (fi g.
1.), screw off the feet and adjust the bottom cover with the four holes
corresponding the screw holes of the feet. Then screw the feet back on
through the cover and fi x it thus securely to the bottom of the machine
(fi g. 2.).
It keeps out the dampness and reduces the noise.
DISMANTLE THE TRANSPORTATION BOLTS
The transportation bolts are designed for clamping anti-vibration
components inside of the washing machine during the transportation
process.
1. Remove the back cover.
2. Remove the three bolts on the rear side and take out the synthetic
stabilisers from within the machine.
3. Replace the back cover.
4. Fill the holes left by the bolts with blanking plugs.
Note: Keep the transportation bolts and synthetic stabilisers in a safe place for later use.
ADJUSTING THE WASHING MACHINE
There are adjustable feet under the bottom of the washing machine.
Before use, they should be adjusted so that the machine is level. This
will minimise vibrations and thus noise during use. It will also reduce wear and tear. We recommend using a spirit level to level
the appliance.
INLET HOSE
1. Connect the nut on the inlet hose to the connector on the water valve.
2. Apply inlet hose to a water tab with cold, fresh water.
BEFORE USE
1.
1.
3.
2.
2.
4.