Troubleshooting - Haier HW-F1481 ME User Manual

TROUBLESHOOTING

TROUBLESHOOTING
The following circumstances do not constitute problems. Do not contact the Service Center until the problem has been confi rmed.
PROBLEM
Washing machine fails to operate.
Washing machine cannot be fi lled
with water.
Machine is draining while being fi lled.
Drainage failure.
Strong vibration while spinning.
Operation stops before completing
wash cycle.
Operation stops for a period of time.
Excessive foam in the drum, which is
spilled to the distribution drawer.
Automatic adjustment of the washing
time.
MAINTENANCE
CAUSES
¬ Poor connection to the power supply.
¬ Power failure.
¬ The washer door is not properly closed.
¬ Machine has not been switched on.
¬ There's no program selected.
¬ Water tap is not turned on.
¬ Water pressure is less than 0,03 Mpa.
¬ The inlet hose is kinked.
¬ Water supply failure.
¬ The program knob is not properly set.
¬ The washer door is not properly closed.
¬ The inlet hose fi lter is blocked.
¬ The height of the drain hose is below 80 cm.
¬ The drain hose is in water.
¬ Drain hose is blocked.
¬ Drain hose end is higher than 100 cm above the fl oor level.
¬ The fi lter is blocked.
¬ Not all transportation bolts have been removed.
¬ Washing machine is located on an uneven surface or is not level.
¬ Machine load is over 8 kg.
¬ Water or electricity failure.
¬ Washing machine is in soaking cycle.
¬ Washing machine is in anti-crease soaking cycle.
¬ Washing machine gives an error message.
¬ The detergent is not a low-foaming type or for manual wash.
¬ Excessive use of detergent.
¬ The washing program duration will be adjusted according to the
laundry load and the initial water temperature.
SOLUTIONS
_ Check connection to the power supply.
_ Check the power supply.
_ Close the washer door properly.
_ Make sure the machine is switched on.
_ Make sure to select a program.
_ Turn on the water tap.
_ Check water pressure.
_ Check the inlet hose.
_ Ensure the water supply.
_ Set the program knob properly.
_ Close the washer door properly.
_ Unblock the inlet hose fi lter.
_ Install drain hose within 80-100 cm of height.
_ Make sure the drain hose is not in water.
_ Unblock the drain hose.
_ Make sure the drain hose end is lower than 100 cm above fl oor
level.
_ Unblock the fi lter.
_ Remove all transportation bolts.
_ Make sure the washing machine is on
an even surface and levelled.
_ Reduce amount of laundry in the drum.
_ Check the power supply.
_ Wait until the cycle is fi nished.
_ It will resume work after some time.
_ Check display codes.
_ Check if your detergent is appropriate.
_ Reduce amount of detergent in the distribution drawer.
_ This is normal and doesn't affect the
functionality.
19