Display Codes - Haier HW-F1481 ME User Manual

18

DISPLAY CODES

DISPLAY CODES AND SPECIAL FUNCTIONS
CODES CAUSES
Err1 ¬ Washer door is not properly shut.
Err2 ¬ Drainage error.
Err3 ¬ Temperature sensor error
(Appears at the end of a cycle).
Err4 ¬ Heater error (Appears at the end of a cycle).
Err5 ¬ Water inlet error.
Err6 ¬ Motor error.
Err7 ¬ Motor error.
Err8 ¬ Water exceeds protective level.
Er10 ¬ Water sensor error.
unb ¬ Laundry is unevenly distributed.
End ¬ End of wash cycle.
1:16 ¬ Status information: remaining program time is 1 hour and 16 minutes.
0:01 ¬ Status information: remaining program time is 1 minute.
60 ¬ Status information: Preset washing temperature is 60° C.
-- ¬ Cold wash.
800 ¬ Status information: Preset spinning speed is 800rpm.
¬ Keyboard is locked.
¬ Control panel lock function: Press the "Delay" and the "Start/Pause" buttons simultaneously for 3 seconds after starting a program. It can no longer be changed by operating buttons or
knobs. The washing machine emits an audible signal while the control panel is locked. To unlock press the "Delay" and "Start/Pause" buttons again for 3 seconds.
¬ Power-off memory function: In case of abrupt power failure or the need to cut off the power during a program cycle, the present settings will be saved and the preset operation will resume
when the power is on again.
¬ This washing machine memorises the previous wash settings for each program. If you press the "Start/Pause" button, the previous settings are automatically selected.
¬ To cancel a program or select a new program and options during the wash cycles.
a) Press the "Start/Pause" button, then switch off the power and the program is automatically cancelled. Turn the program selector again to choose another program.
b) If you wish to select an option during the wash cycle, press the "Start/Pause" button, then select the desired option and press the "Start/Pause" button again.
Note: The Rinse hold function can be selected directly without pressing fi rst the "Start/Pause" button, but before the machine starts the spin program.
MAINTENANCE
SOLUTIONS
_ Close the washer door properly
_ Clean the fi lter and check the drain hose for blockage.
_ Please contact the Service Center.
_ Please contact the Service Center
_ Check the tap and the water pressure.
_ Please contact the Service Center.
_ Please contact the Service Center.
_ Please contact the Service Center.
_ Please contact the Service Center.
_ Redistribute laundry to balance the drum.