Installing The Riser 1 Blank; Removing Expansion-Card Risers - Dell Precision Rack 7910 Owner's Manual

Figure 22. Removing and installing the riser 1 blank
1. slot on the chassis
3. riser 1 blank

Installing the riser 1 blank

1. Align the blank with the slot on the chassis.
2. Insert it into the chassis until it clicks into place.

Removing expansion-card risers

CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you read the
2. Follow the procedure listed in
3. If installed, remove any expansion card installed on riser 2 and 3.
NOTE: The expansion-card riser 1 can be used only when both the processors are installed.
Holding the slots on the expansion-card riser, lift the riser from the riser connector on the system
board.
56
Safety instructions.
Before working inside your
2. tab (2)
system.