Table of Contents
Advertisement
Program Mode
KB3 Editor: The LFO, ASR, and FUN Pages
KB3 Editor: The OUTPUT Page
Use this page to route the current program's post-FX signals. The two Pan parameters
correspond to those of the VAST Program editor OUTPUT page (See
and Demo Song parameters correspond to those of the VAST Program Editor COMMON page
(See
page
Exp Pedal
Use this parameter to set which rear panel CC Pedal input will control volume for the current
KB3 program. With a setting of Expression/Foot, volume can be controlled by a CC pedal
plugged into either the rear panel input labeled CC Pedal 1 (volume), or the rear panel input
labeled CC Pedal 2 (wah). With a setting of Expression, volume can be controlled by a CC pedal
plugged into the rear panel input labeled CC Pedal 1 (volume). With a setting of Foot, volume
can be controlled by a CC pedal plugged into the rear panel input labeled CC Pedal 2 (wah). With
a setting of None, volume control from both CC pedal inputs is disabled.
KB3 Editor: The Program FX (PROGFX) Page
This page is the same as the VAST Program editor PROGFX page (see
important difference: there is no Pre/Post insert parameter for the auxiliary sends.
KB3 Editor: The LFO, ASR, and FUN Pages
The rest of the pages—LFO, ASR, and FUN— are the same for KB3 programs as they are for
VAST programs, so we won't describe them again here. Begin on
these pages.
6-70
6-35).
page
6-31). The Out Gain
page
6-47) except for one
page 6-38
to find descriptions of
Advertisement
Table of Contents
