Select Satellites - TracVision M9 Installation Manual

Select Satellites

11
Follow these steps to turn on the system and
select satellites for tracking.
a. Ensure the antenna has a clear, unobstructed
view of the sky.
b. Apply power to the receiver(s), TV(s), and
MCU. Wait two minutes for system startup.
c. Press the center MENU button on the MCU to
access the Install Satellite menu (see
Figure 27).
d. At "Install Satellite?", press YES.
e. Now you need to set the MCU to track the
satellites of your choice. You can select from
preset satellite groups of three satellites, or
you can choose up to three satellites from
over 70 satellites in the satellite library. Please
refer to "Setting the MCU to Track Satellites"
in the TracVision M9 User's Guide for
complete information.
NOTE: DISH 1000 customers with the DISH 129
satellite installed must have a multiswitch installed to
enable manual switching, or a Master Receiver
Selector (MRS) (KVH Part #72-0412) to enable
automatic (or manual) switching. The MRS also
allows you to select which receiver is the master
receiver.
f. Linear Versions - Set up the receiver(s) for the
same satellites, and in the same order, as the
antenna. "Sat. A" is the first satellite you
selected for tracking; "Sat. B" is the second;
"Sat. C" is the third (see
14
Figure 28).
Figure 27 Install Satellite Menu
T r a c k i n g S a t e l l i t e A
S a t B M e n u S a t C
Install Satellite?
Yes Next Return
Figure 28 Linear Receiver Settings
Antenna Receiver
Sat. A Alternative 1 or A
Sat. B Alternative 2 or B
Sat. C Alternative 3 or C
DiSEqC
DiSEqC 1
DiSEqC 2
DiSEqC 3