Download Print this page

To Switch On From Standby Or To Standby - Pro-Ject Audio Systems Pro-Ject Head Box S Instructions For Use

Headphone amplifier

Advertisement

To switch on from standby or to standby

The push button on the left hand side will toggle the unit between its fully operational status and standby. The
blue LED above the stand-by push button shows that the unit is switched on.
Technical specifications Pro-Ject Head Box S
Power output:
Headphone connection:
Signal to noise:
Frequency response:
THD (IMD):
Gain:
Headphone jack:
Line-level output:
Outboard power supply:
Power consumption:
Dimensions W x H x D (D with sockets): 103 x 36 x 104 (109)mm
Weight:
Potential incorrect use and fault conditions
No signal on one or both channels:
No connection between headphone and headphone amplifier ore amplifier. This could be due
to a faulty plug, broken wire or solder joint or simply loose plug/socket connection.
Headphone does not work:
Headphone volume control is at minimum.
Amplifier Tape-Monitor circuit is not activated.
Service
Should you encounter a problem which you are not able to alleviate or identify despite the above information,
please contact your dealer for further advice. Only when the problem cannot be resolved there should the
unit be sent to the responsible distributor in your country.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or change to any part of the product by unauthorized persons release the
manufacturer from any liability over and above the lawful rights of the customer.
Copyright
PRO-JECT is a Registered Trademark of H. Lichtenegger.
This guide was produced by: Audio Trade GmbH
©
Copyright
2011. All rights reserved.
330mW/30ohms, 60mW/300ohms
> 30ohms
112dB (A weighted) at full output
30Hz – 20kHz/-0,05dB (10Hz – 120kHz/-1dB)
0,003% (0,002%)
11dB
3-pole ¼" (6,3mm ) co-axial jack
1 pair RCA/phono sockets
18V/500mA DC, suitable for your country's mains supply
100mA DC, <1W in standby
600g without power supply
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.
© Audio Trade GmbH · Pro-Ject Head Box S · Revision 2013.1.15
3

Advertisement

loading

This manual is also suitable for:

Head box s