Service Mode - W1966 And W1986 - Miele W1903 User Manual

Technical Information
6.2

Service Mode - W1966 and W1986

Access
1. Switch Off the appliance. Close the Door.
2. Turn the Program Selector Switch to 12 o'clock.
3. Press and hold the Buzzer and Extended Buttons.
4. Switch On the appliance.
5. Release the Buzzer and Extended buttons.
Acknowledgement Indicator
Successful access into the Service Mode is indicated by a flashing
"Pre-Wash" LED. (On the W1986 the display shows the microprocessor
ROM ID code. Example: -08)
Navigation
Turn the Program Selector Switch to the desired position in accordance
with the Table 6-2 – Service Mode Functions.
Selector Switch Program
COTTONS 190
COTTONS 140
COTTONS 120
COTTONS 105
PERMA PRESS 105
COTTONS COLD
PERMA PRESS 140
PERMA PRESS 120
WOOLENS 85
DELICATES COLD
DELICATES 85
DELICATES 105
Table 6-2: Service Mode Functions (W1966 & W1986)
W1900 Series Clothes Washers
Function
Water intake via Pre-Wash valve. Water
reaches level 1 position then heaters are
activated up to 95º F.
Water intake via the Main Wash valve until
water level 2 is reached.
Water intake via the Rinse Valve until water
level 3 is reached.
(Not Used)
Water intake via Hot Water Valve.
Drain Pump is activated.
Drum rotates w/ reverse action.
Drain pump operates, drum spins to set spin
speed on control panel (up to 1200 rpm
only).
*See the Fault Code Retrieval / Clearing
section 100 – 4.2 (next page)
Buzzer activated.
LED flashing test.
Operating hours in blocks of 3. (Example:
9423 hours would be shown as "009" then
"423") Note: Applies to W1986 only.
50