Table 6-8: Fault Indicators (Continued From Table 6-7) (Continued On Table 6-8) - Miele W1903 User Manual

Technical Information
"Water Inlet Check"
Table 6-8: Fault Indicators (Continued from Table 6-7, Continued on Table 6-8)
Indicator
The Tachogenerator connections are open or short
circuited. The motor is switched off within 1.5
seconds. Another attempt is made to start the motor
at the next reversing phase, but it will stop if the
conditions still exist.
"Rinses 1-2"
LED flashes
The Drive Motor does not start with 1.5 seconds
due to open wiring in the motor circuit, defective
brushes, etc...
A Control Module fault has been detected.
"Rinse 3"
LED flashes
This fault is indicated immediately when the
appliance is switched on.
Operational error. The operator has selected "Rinse
Hold" with the Spin Speed Selector Switch and then
"Rinse Hold"
set the program Selector Switch to "Spin". The
flashing "Rinse Hold" LED indicates that this
LED flashes
contradictory setting must be changed. See the
Operating Instructions for further details.
In the last 2 seconds of the final spin, the spin
"Final Spin"
speed must be > 400 rpm. If this is not the case the
"Final Spin" LED flashes, however the program
LED flashes
continues.
Water Intake Failure. The Water Inlet System is
time controlled. If the correct water level is not
registered by the Level Switch in the allotted time,
the fault will be indicated as follows:
LED flashes
Note: the water level can be extended on certain
models, refer to the model specific Operating
Manual for further details.
64
W1900 Series Clothes Washers
Information
OR
The LED flashes if water level 1 has not
been reached after 2 minutes.
If the correct water level has still not been
reached in 4* minutes, the Inlet Valves are
closed and the program is cancelled. A 90
second drain is then initiated and the LED
remains flashing until the program has
stopped.