Miele W1903 User Manual page 58

W1900 Series Clothes Washers
Technical Information
the intake valve is opened again. This continues until the laundry cannot
absorb any more water. The absorbing times and the valve switching
times are parameters being used to establish a provisional loading level.
The amount of water used for the rinse cycles is in conjunction with the
loading level established at the first fill. DO NOT CHANGE.
WATER LEVEL (Delicates 85)
This programs the function performed when the Sensitive option is
selected via the Control Panel. The default setting adds extra water to the
main wash and rinse cycles of a program to thoroughly wash away
detergent scent and allergens. This option is available in the following
programs: Cottons / Permanent Press / Jeans / Dress Shirts and Silk. DO
NOT CHANGE.
WATER INTAKE (Delicates Cold)
The optional setting allows for additional water intake monitoring time. It
will change this time from 60 seconds to 255 seconds. If the Hot Water
Valve (Y12) is opens and the first water level is not registered within 30
seconds, Y12 closes and the Cold Water Valve Y1 opens. If no water
level is registered after 60 seconds the buzzer sounds and the LED Water
intake starts flashing.
PROGRAMMING MODEL NUMBER (Silks)
If an electronic unit needs to be replaced it must be programmed to match
the model number of the appliance. Two models numbers are available in
USA and Canada (W1966 and W1986) the Electronic should be
programmed only to the exact model number it is installed in.
HEATER RATING (Woolens 105)
The washer can be equipped with a variety of Heating Elements. For the
USA and Canada the Heating Elements are 2x1300 Watts and should be
programmed accordingly. DO NOT CHANGE.
SOAK BUTTON (Woolens 85)
This programs the function performed when the Soak option is selected
via the control panel. The default setting allows a soak action to be
performed when the soak button is pressed. The optional setting
programs the button as Gentle Wash instead.
SOAK DURATION (Woolens)
W1966: Programs the soak time duration – applies only if the user selects
the soak option. Default setting is 120 minutes.
W1986: Does not apply - DO NOT CHANGE.
58