Table of Contents
Advertisement
How to Operate the Setup Mode
Your McIntosh MHA100 has been factory configured
for default operating settings that will allow immedi-
ate enjoyment of superb audio without the need for
further adjustments. If you wish to make changes to
the factory default settings, a Setup Feature is pro-
vided to customize the operating settings using the
Front Panel Display. Refer to the MHA100 Front Panel
Illustration on the previous page while performing an
introduction into operating the Setup Mode, follow the
steps below.
Note: If the MHA100 is currently On, proceed to
step 2.
1. Press the STANDBY/ON Push-button on the Front
Panel or press the
(Power) Push-button on the
Remote Control to switch On the MHA100. The
MHA100 will go through a brief startup intializa-
tion with the Front Panel Display indicating the
last used input and volume setting. This is fol-
lowed by the volume setting indication starting at
zero and then increasing to the last used volume
setting. Refer to figure 1.
INPUT:
UNBAL
20%
Figure 1
2. Press and hold in the INPUT CONTROL until the
Front Panel Display indicates "MHA100 V_.__,
S/N: _______". The information indicated on the
Front Panel Display includes the Model Number,
Firmware Version and the Serial Number for this
unit; see page 18 for additional information. Refer
to figure 2.
MHA100
V_.__
S/N: _______
Figure 2
3. Now rotate the INPUT CONTROL Clockwise
until the Front Panel Display indicates "McIntosh
USB AUDIO, V_.__ Firmware". Refer to figure 3
and to page 18 for additional information.
MLI USB Audio
V_.__
Figure 3
4. Next, rotate the INPUT CONTROL Clockwise
again until the Front Panel Display indicates
"SOURCE: UNBAL, NAME: UNBAL" Refer to
figure 4.
INPUT:
UNBAL
NAME:
UNBAL
Figure 4
5. Rotate the INPUT CONTROL Clockwise again
to select other Setup Functions. Refer to pages 18
thru 20.
6. To exit from the Setup Mode, press the INPUT
CONTROL and the Front Panel Display will revert
back to its normal display. Refer to figure 1.
Default Settings
The Default Settings Chart below indicates the Func-
tion Name, Default Setting and the Page Number for
additional information.
Default Settings
Function Name
Setting
V_._ _
MHA100
S/N: _ _ _ _ _ _ _
McIntosh USB Audio
V_.__
INPUT NAME
INPUT:_________
(Re-asign Input Names)
NAME:__________
SPEAKER MODE
LARGE
SUBWOOFER MODE
DISABLED
POWER MODE
ON
(Auto Off)
REMOTE CONTROL
ENABLED
Note: Setup Mode operations should be performed
in the order they appear in the Setup Menu as
they are interactive.
Setup
Page No.
18
18
18
19
19
20
20
17
Advertisement
Table of Contents
