Reconyx UltraFire User Manual page 10

Home Tab: Main Menu Items
Arm Camera – When you select this option, you
will be taken to the ARM CAMERA page. You then
can confirm that you want the camera to take Still
Photos, Videos and utilize a Quiet Period after
the motion event. You can use the direction
buttons to make your choices regarding these
options and then push the OK button once the
ARM field is highlighted at the bottom of the
screen. The camera will arm in ten seconds unless
you cancel it before the countdown is complete by
pressing the OK button.
Test Motion Sensor (also called WalkTest) – When you select this option your
camera flashes a red indicator light so that you can test its aim by walking in front
of it. The WalkTest mode shows you exactly where the camera's active motion
detection zones are located. The tilt of the camera is critical, as slight changes
are magnified at greater distances from the camera.
TIP: If left in Motion Sensor Test mode, the camera will automatically arm itself
after 2 minutes with no motion events. This allows you to set the camera
up, check its aim using WalkTest, and then just walk away.
View Pictures – When you select this option, the
camera will enter into a slide show function. The
LEFT and RIGHT directional buttons will allow you
to scroll through the images on the memory card.
The UP directional button will engage a pan/zoom
feature while the DOWN directional button will
allow you to delete the image being viewed at that
time. Pressing the OK button will allow you to exit
from the slide show and return you to the Home
page.
9 ©RECONYX, Inc.