Impulse Mode; Removing The Drill Chuck; Tips And Tricks; Maintenance - Metabo SB 660 Operating Instructions Manual

SBE 1010 NAFTA.book Seite 10 Mittwoch, 25. Januar 2006 3:07 15
ENGLISH
ENG

7.13 Removing the drill chuck

Keyless chuck Futuro Top (3)
Remove the chuck with two open end spanners.
Keyless chuck Futuro Plus (2)
Remove locking screw. Caution: left-handed
thread!
Hold machine spindle with an open end spanner.
With a rubber mallet tap lightly on a chucked Allen
key to loosen the chuck.
Geared chuck (1)
Remove locking screw. Caution: left-handed
thread!
10
Hold machine spindle with an open end spanner.
Loosen chuck by lightly tapping on the inserted
key with a rubber mallet, then remove fully.

8 Tips and Tricks

When drillling deep holes, pull the drill bit out of the
hole from time to time to clear the stone dust or
chips.
Drill tiles and other brittle materials without impact.
To start drilling without centering, activate the
impulse mode (SBE 850 Impuls).
For screw driving the drill chuck can be removed.
Insert screwdriver bit directly into the spindle's
hexagon socket.
Attach the screwdriver-bit retaining bush to hold
the screwdriver bit.
For tapping (not SB 660), apply a little cutting oil to
the tap. Select a low speed and
clockwise rotation and tap hole, stop machine and
switch to counter-clockwise rotation to remove
tap.

9 Maintenance

Keyless chuck cleaning:
After prolonged use hold the chuck vertically, with
the opening down, and fully open and close it
several times. The dust collected falls from the
opening. The application of cleaning spray to the
jaws and jaw openings at regular intervals is
recommended.

10 Trouble Shooting

If the trigger (13) can not be depressed, check to
see that the rotation selector switch (14) is fully set
to position R or L (not SB 660).
SBE 850 pulse: When the machine is switched on,
if the thumb-wheel (9) is turned from pulse function
to torque control, the machine will switch off
automatically. Switch the machine off and then
back on again.
. Set for