Setup; Attaching The Memory Recorder To A Camcorder - JVC KA-MR100G Instructions Manual

Setup

Attaching the Memory
Recorder to a Camcorder
Check the IEEE1394 connection method before attaching
the memory recorder to the camcorder.
For details, please refer to AConnecting IEEE1394B
(A Page 7)
Note:
● The KA-MR100G adapter (sold separately) is required to
attach the memory recorder to a camcorder.
:
Memo
● Two different types of battery adapters, manufactured by
IDX and Anton Bauer respectively, are available,
depending on the country/region where the camcorder is
purchased.
1 Remove the battery from the camcorder
2 Remove the battery adapter from the camcorder
Follow the steps illustrated in A _ C below to remove the
battery adapter, followed by the plate (for IDX adapters only)
and rubber sheet from the camcorder.
Rubber sheet
(included with the camcorder)
C Remove screw B (x4)
Screw B
Plate (for IDX
adapters only)
Connector
B Remove connector (x2)
:
Memo
● Battery adapters manufactured by Anton Bauer do not
come with a plate.
3 Attach the KA-UM100G adapter (sold separately)
to the camcorder
Align the screw holes at the back of the camcorder with the
holes on the rubber sheet. Next, follow the steps illustrated in
A _ B to attach the KA-UM100G adapter.
Rubber sheet
(included with KA-UM100G)
Note:
● Store the connection wires and connectors properly so that
they do not protrude from the groove or recess.
Battery adapter
A Remove screw A
Screw A
(x4)
Screw
A
Battery adapter
for Anton Bauer
KA-UM100G adapter
Screws
B Mount the
screw (x4)
A Connect the
Connector
connector (x2)
Recess
4 Attach the memory recorder to the KA-UM100G
adapter
Align the screw holes at the back of the KA-UM100G adapter
with the holes on the rubber sheet. Next, follow the steps
illustrated in A _ D to attach the memory recorder.
B Set the hook to the guide
KA-UM100G
Guide
adapter
Recess
Connector A
A Connect
Rubber sheet
connector A
(included with the
memory recorder)
Note:
● Store the connection wires and connectors properly so that
they do not protrude from the groove or recess.
5 Attach the battery adapter to the memory
recorder
Align the screw holes at the back of the memory recorder
with the holes on the rubber sheet. Next, follow the steps
illustrated in A _ C to attach the rubber sheet, plate (for IDX
adapters only) and battery adapter.
Rubber sheet
(included with the camcorder)
A Mount screw B (x4)
Screw B
Plate (for IDX
adapters only)
Connector
B Connect the connector (x2)
Note:
● Store the connection wires and connectors properly so that
they do not protrude from the groove or recess.
:
Memo
● Battery adapters manufactured by Anton Bauer do not
come with a plate.
6 Attach the battery to the camcorder
Note:
● Do not use the battery that cannot be connected with this
product.
For details, please refer to the instruction manual of the
camcorder.
Memory recorder
Hook
(KA-UM100G)
Screws D Mount the
screws (x2)
Connector B
C Connect
connector B
Battery adapter
C Mount screw A (x4)
Screw A
Screw A
Battery
adapter for
Anton Bauer
6