Before Using For The First Time; Installing The Unit; Connecting To The Analog Output Jacks; Connecting To The Digital Output Jack - JVC XL-Z132BK Instructions Manual

BEFORE USING FOR THE FIRST TIME

Installing the unit

Best location
Select a location which is level, dry and neither too cold nor too hot
(temperature range 5°C (41°F) to 35°C (95°F)). Also, avoid dusty
locations or any location subject to vibration.
If interference occurs
If this equipment is placed near a tuner or a radio receiver tuned to AM
frequencies, interference may occur. If this happens, we recommend
either that you move this unit as far away as possible from the tuner or
receiver or briefly turn off the power to this unit.
Connecting to the Analog
Output Jacks
Connecting to an amplifier or receiver allows you to listen to the sound
from the speakers.
Connect the OUTPUT jacks of this unit to the line input jacks of an
amplifier or receiver with the supplied audio cord.
Notes
÷ Never connect the OUTPUT jacks to the PHONO jacks of the
amplifier or receiver. This may cause damage to the components.
÷ Make sure that the same channels are connected between this unit
and the amplifier or receiver: LEFT to LEFT and RIGHT to RIGHT.
÷ Do not connect the power plug unless all connections are com-
pleted.
÷ Connect the plugs firmly. Loose connections may cause noise or
malfunction.
Rear panel of this unit
DIGITAL OUT
OPTICAL
COMPULINK-3
OUTPUT AC IN
SYNCHRO
LEFT
RIGHT
Audio cord
OUTPUT
LEFT
RIGHT
Amplifier or receiver
Speaker unit
Connecting to the Digital
Output Jack
It is possible to transmit a digital sound signal from this unit directly to
a MD recorder,etc.
Notes
÷ Never connect the digital out put cable except to the digital input jack.
÷ An optical digital cord (optional) is required to make this connection.
Refer to the instruction manual of the MD recorder, etc. for details.
÷ There is a protective cap on the DIGITAL OUT jack (optical) . When
making the connection, pull off this cap and store it carefully in a safe
place. Should you undo the connection, replace the cap on the jack.
OPTICAL
DIGITAL
OUT
Optical digital cord (optional)
DIGITAL OUT
OPTICAL
COMPULINK-3
OUTPUT AC IN
SYNCHRO
LEFT
RIGHT
Rear panel of this unit
MD recorder, etc.(optional)
Page 4