Warning - Gemini NCB-D200-IR User Manual

Warning

경 고
1. Do not install, disassemble or modify the product at your discretion. It might cause product
damage, electric shock or fire. When the device is out of order, please contact the local agency
for warranty service.
2. Do not operate the device while driving. It might be a cause of car accident. If the device
operation is required, stop the car at a safe parking lot and operate the device.
3. Do not use in trouble condition as like smoking, smell something burn. It may cause fire. Stop
to use and make inquiries to agency.
4. Do not clean the device with water. The device is not waterproof. It may cause malfunction,
electric shock or fire.
5. Unplug product when do not use the device for a long time. It may cause fire by short circuit
due to heating.
6. Do not place near of air bag effective range. It may cause malfunction of air bag or accident,
injury due to hitting the device by air bag.
7. Keep clean dust on power socket. It may cause electric shock and fire by bad connection.
8. Do not put a pin or needle on the hole or crack in the device body. In case those things are
inserted by mistake, stop operating. It may cause electric shock, fire and malfunction.
9. Attach the device on the windshield firmly. Clean the front windshield and attach the device
firmly. Otherwise the device may be detached due to temperature, humidity, dust or shock.
9. Use power cable supplied with the device when it is installed. If qualified cable is not used, it
might cause electric shock, fire and malfunction.
10. When the device is installed with continuous power cable, only a qualified engineer has to
install the device. If the device is not correctly connected, it causes damage to the vehicle and the
product.
11. Do not clean exterior with volatility or oily solvent. Neither keeps touching rubber and plastic
for long time. It may cause change of surface, fall of paint, malfunction and fire.
12. Do not pull cord with a jerk. Catch a plug and pull. Do not use damaged cord. It may cause
cord malfunction, electric shock and fire.
13. Before installation, the engine has to be turned off. It may cause an electric shock or defect.
※ The device has always to be installed at the place where the driver ‟s view is not
interrupted.
4