Operation; Dual Recording; Continuous Recording - Gemini NCB-D200-IR User Manual

Operation

Joystick Speaker
User can easily understand the status of operations with the
voice announcement while the joystick is touched.
Recording
Insert SD Card and connect the power cord. If everything is fine, LED will light within 3~7 seconds. Then, the unit starts to
record two images from two cameras.
♣In vehicle recording is selected. Recording will begin.
Remarks: Please push SD card to get the SD card from the unit after LED turns off completely. To push SD card while LED
lighting causes a damage of the recorded file.
When accident is occurred, please plug out of the power cable from the device and wait until indication LED is off. Then,
push the SD Card to remove the SD memory card.

Dual Recording

Whenever power is on, recording will begin. Tow cameras will record simultaneously tele & wide images or inside &
outside images.

Continuous Recording

- When a power cable is connected to a constant power terminal at the vehicle, continuous recording is possible.
- While parked, the device records continuously up to maximum SD memory card size. When the memory is full, the
device deletes the file in the order of early recording time and keeps recording with over-writing.
- As a battery discharge protection circuit is built inside, vehicle battery is protected while the device is working. And if the
battery is low, the device will stop working.
(When it is required to connect the device power to continuous power terminal of the vehicle, please visit professional
installation shop and check the safety and functions. It is for customer‟s safe use of the device and the vehicle)
- The device has a battery discharge protection function. But for safe and long using of the battery, please do not operate
continuous recording for long time. Please engine on at least a two or three days.
12