Berghoff 1810027 - 2216743 Manual page 20

Induction cooktop tronic-line
Hide thumbs Also See for 1810027 - 2216743:
Table of Contents

Advertisement

agents that are used for cleaning the glass top.
After the cleaning procedure, you should use a soft and dry cloth to wipe dry and
polish the surface.
7B. Cleaning
Clean after each use. Disconnect the powerplug and wait until the unit has cooled
down.
If the pots/pans that are used are not clean, staining or discoloration may occur.
At first, you should clean the glass field with a damp cloth or a mild, non-abrasive
soap solution.
Wipe off the operating panel with a soft cloth or a mild detergent.
Do not use benzene, thinner, a scrubbing brush or polishing powder to clean the
induction cooker.
It will damage the plastic parts and the operating panel.
Use a vacuum cleaner to suck up dirt from the air intake and exhaust vent.
Never run water over the unit (If water gets inside it may cause malfunction).
Make sure that the base of the cookware does not scrape across the surface of the
glass field, although a scratched surface does not impair the use of the cooktop.
Make sure that the cooktop is cleaned and dried properly for storage and further
usage.
7C. Maintenance
Check the main connection cable for damage from time to time. Never operate the
cooktop when the cable is damaged. If the main connection cable shows defects,
have it replaced by a qualified electrician.
When you encounter damages or failures, contact your specialized dealer or our
customer service.
Only qualified experts may perform repair and maintenance work on the appliance
using original replacement and accessory parts. Never attempt to repair the appliance
yourself!
8. Waste disposal
Waste devices
At the end of its service life, the discarded device has to be disposed in accordance with the na-
tional waste disposal and recycling regulations. It might be advisable to contact a company which
specializes in waste disposal.
!
WARNING: To avoid risks involved with waste disposal, disconnect the device from the main supply
and remove the main connection cable from the device.
- 0 -

Advertisement

Table of Contents
loading

Table of Contents