Setting Up The Handset For Use - Siemens Gigaset C450 User Manual

First steps
Connecting the base station
¤
First connect the power supply unit
and then the phone jack as shown
below and place the cables in the cable
recesses.
Gigaset C470
1
1
Gigaset C475
1
1
1 Mains adapter 230 V
2 Phone jack with phone cord
Please note:
u
The mains adapter must always be
connected, as the phone will not
operate without mains connection.
u
Only use the mains adapter and phone
cord supplied.
u
If you buy a replacement phone cord,
make sure that the phone jack has the
correct type of wiring.
Correct phone jack assignment
3
2
1
8
2
2
1 unused
4
2 unused
5
3 a
6
4 b
5 unused
6 unused

Setting up the handset for use

The display is protected by
a plastic film. Please
remove the protective
film!
Inserting the batteries
Warning:
Use only the rechargeable batteries recom-
mended by Siemens (page 56). Never use a
conventional (non-rechargeable) battery or
other battery types as this could result in sig-
nificant health risks and personal injury. For
example, the batteries could explode. The
phone could also malfunction or be damaged
as a result of using batteries that are not of the
recommended type.
¤
Insert the batteries the right way
round.
The polarity is indicated in/on the battery
compartment.
Closing the battery cover
¤
First insert the battery cover at the top.
¤
Then press the cover until it clicks into
place.