Assigning Names To The Sources (Only For Kd-Sx985) - JVC KD-SX985, KD-SX885 Instructions Manual

Assigning names to the sources
This section is only for KD-SX985.
You can assign names to station frequencies and
discs (both in this unit and in the CD changer).
After assigning a name, it will appear on the display
when you select the source.
Sources
Station frequencies
CDs*
* You cannot assign a name to CD Text or an MP3 disc.
1
Select a source you want to assign a
name to.
2
Press and hold SEL (select) for more
than 2 seconds while pressing DISP
(display).
Ex.: When you select CD as the source
30
Maximum number of
characters
up to 8 characters (up to
30 station frequencies
including both FM and AM)
up to 32 characters
(up to 40 discs)
When you select a source,
the power automatically
comes on.
3
Select a character.
• See below for available
characters.
4
Move the cursor to the next (or
previous) character position.
5
Repeat steps 3 and 4 until you finish
inputting the name.
6
Finish the procedure while the last
selected character is flashing.
To erase the input characters
Insert spaces using the same procedure
described above.
Available characters
A B C D E
K L M N O
U V W X Y
4 5 6 7 8
space
Notes:
• When you try to assign a name to the 41st disc,
"NAME FULL" appears on the display. (In this
case, delete unwanted names before assignment.)
• When the CD changer is connected, you can assign
names to CDs in the CD changer. These names can
also be shown on the display if you insert the CDs in
this unit.
F G H I J
P Q R S T
Z 0 1 2 3
9
– / < >