Table of Contents
Advertisement
"Table" position fig. 38
Proceed as follows to tip the bench
seat back in "table" position:
– flatten the head restraints;
– lift lever C and guide the seat back
to the cushion.
To restore the seat back vertical po-
sition, push it upwards until it clicks
and locks in that position.
"Wallet" position fig. 38
Proceed as follows to tip the bench
seat in "wallet" position:
– flatten the head restraints;
– lift lever C and guide the seat back
to the cushion;
30
fig. 38
– pull handle D and release the an-
chorages from their housing on the
floor, then fold the bench seat as a
"wallet".
To restore the bench seat normal
position, guide the tipped seat until it
engages the runners on the floor, then
put the seat back into vertical position
until it clicks and locks in that position.
Dismantling the bench seat
fig. 38
To dismantle:
– fold the bench seat as a "wallet" ac-
cording to the above mentioned pro-
cedure;
– lift lever E while making it closer
to bar F, then grip them both and re-
move the bench seat from its housing
on the floor runners.
To
thereafter
the bench seat, it is nec-
essary to keep the backrest firm-
ly folded and flattened onto the
cushion, in order to avoid any risk
of contact with the articulation
mechanisms of the seat itself.
Make sure the anchor-
age holes are always
clean; if debris has got in-
to them it interferes with the
seats being locked securely into
place.
F0B0022b
Before starting off again,
make sure that the seats
are facing the front of the
vehicle and are properly fastened
to their anchorage points. The
seat belts can only be used effec-
tively in this position.
disassemble
and
reassemble
Advertisement
Table of Contents
