Maintenance; Light Bulb Replacement - Dimplex DF2690 Owner's Manual

Maintenance

WARNINg: Disconnect the
power before attempting any
maintenance or cleaning to
reduce the risk of fire, electric
shock or damage to persons.

Light Bulb Replacement

Allow at least five (5) minutes
for the light bulbs to cool before
touching them to avoid accidental
burning of the skin. The light
bulbs need to be replaced when
you notice a dark section of
the flame or when the clarity
and detail of the log ember bed
exterior reduces. There are three
(3) bulbs under the log set, which
generate the flames and embers,
and two (2) bulbs above the log
that illuminate the log exterior.
Helpful Hints: It is a good idea to
replace all light bulbs at one time
if they are close to the end of their
rated life. Group replacement will
Figure 7
Lower
Bulbs
Log set
Upper
Bulbs
Trim
Front
Glass
reduce the number of times you
need to open the unit to replace
light bulbs. Care must be taken
when removing the log set as the
log set contains LED's and wires.
Lower Light Bulb Requirements
Quantity of three (3) clear
chandelier or candelabra bulbs
with an E-12 (small) socket base,
60 Watt rating. Example: GE
60BC or Philips 60 CTC.
Do not exceed 60 Watts per
bulb.
To access the lower light bulb
area:
1. slide fireplace out of mantel.
2. Lay unit on it's back for safe
removal of front glass.
3. Remove four (4) Phillips
screws from the right side of
trim.
4. Slide glass to right side of
Figure 8
Back
Ledge
Rear
Tab
side section
Log
Ember bed
Front
Edge
15