Precor 9.21 Service Manual page 18

Table 5.2. Voltage Test Points (Function Keys Pressed)
Place the positive
voltmeter lead on...
Pin 3 of J4
Pin 4 of J4
Pin 5 of J4
Pin 7 of J4
Pin 8 of J4
Pin 9 of J4
Pin 10 of J4
7. If the voltage readings match those listed in Tables 5.1 and 5.2 and one or more keys do not
function, replace the upper PCA.
8. If the voltage readings in Table 5.1 are incorrect, disconnect the keypad cable from the key
pad connector and repeat the voltage measurements in 5.1. If the voltage readings are now
correct, replace the display housing (keypad). If the voltage readings are still incorrect,
replace the upper PCA.
9. If the voltage readings in Table 5.1 are correct and one or more voltage readings in Table
5.2 are incorrect, replace the display housing (keypad).
10. Set the circuit breaker in the "off" position.
11. If necessary, carefully re-connect the keypad cable to the keypad connector.
12. Remove the ground lead of the wrist strap from the treadmill frame, then remove the wrist
strap from your arm.
13. Position the display enclosure on the display plate. Install the screws that secure the display
enclosure to the display plate.
14. Check the operation of the treadmill as described in Section Three of this appendix.
At the electronic
console, press...
ENTER
INCLINE DOWN
INCLINE UP
STOP
SPEED DOWN
SPEED UP
QUICK START/CHANGE
9.21, 9.21i, 9.21S, 9.21Si Treadmill
The voltmeter should
read between...
0 Vdc and 500 mVdc
0 Vdc and 500 mVdc
0 Vdc and 500 mVdc
0 Vdc and 500 mVdc
0 Vdc and 500 mVdc
0 Vdc and 500 mVdc
0 Vdc and 500 mVdc
Page 18