Table of Contents
Advertisement
set security ipsec tunnels name "123" IKE-mode
isakmp-SA-encrypt { DES | 3DES }
See
page 201
for details about SafeHarbour IPsec tunnel capability.
set security ipsec tunnels name "123" IKE-mode ipsec-mtu mtu_value
The Maximum Transmission Unit is a link layer restriction on the maximum number of bytes of data in a
single transmission. The maximum allowable value (also the default) is 1500, and the minimum is 100.
set security ipsec tunnels name "123" IKE-mode isakmp-SA-hash
{ MD5 | SHA1 }
See
page 201
for details about SafeHarbour IPsec tunnel capability.
set security ipsec tunnels name "123" IKE-mode PFS-enable { off | on }
See
page 201
for details about SafeHarbour IPsec tunnel capability.
set security ipsec tunnels name "123" IKE-mode invalid-spi-recovery
{ off | on }
Enables the Gateway to re-establish the tunnel if either the Motorola Netopia® Gateway or the peer
gateway is rebooted.
set security ipsec tunnels name "123" xauth enable {off | on }
Enables or disables Xauth extensions to IPsec, when IKE-mode neg-method is set to aggressive.
Default is off.
set security ipsec tunnels name "123" xauth username username
Sets the Xauth username, if Xauth is enabled.
set security ipsec tunnels name "123" xauth password password
Sets the Xauth password, if Xauth is enabled.
set security ipsec tunnels name "123" nat-enable { on | off }
Enables or disables NAT on the specified IPsec tunnel. The default is off.
set security ipsec tunnels name "123" nat-pat-address ip-address
Specifies the NAT port address translation IP address for the specified IPsec tunnel.
197
Advertisement
Table of Contents
