Motorola Netopia 7000 Administrator's Handbook page 183

Embedded software version 7.8.2
Hide thumbs Also See for Netopia 7000:
Table of Contents

Advertisement

set ip static-routes
Specifies the network address for the static route. Enter a network address in the net_address
argument in dotted decimal format. The net_address argument cannot be 0.0.0.0.
set ip static-routes
Specifies the subnet mask for the IP network at the other end of the static route. Enter the netmask
argument in dotted decimal format. The subnet mask associated with the destination network must
represent the same network class (A, B, or C) or a lower class (such as a class C subnet mask for class
B network number) to be valid.
set ip static-routes destination-network net_address
interface { ip-address | ppp-vccn }
Specifies the interface through which the static route is accessible.
set ip static-routes destination-network net_address
gateway-address gate_address
Specifies the IP address of the Gateway for the static route. The default Gateway must be located on a
network connected to the Motorola Netopia® Gateway configured interface.
set ip static-routes destination-network net_address metric integer
Specifies the metric (hop count) for the static route. The default metric is 1. Enter a number from 1 to
15 for the integer argument to indicate the number of Gateways (actual or best guess) a packet must
traverse to reach the remote network.
You can enter a metric of 1 to indicate either:
K The remote network is one Gateway away and the static route is the best way to reach it;
K The remote network is more than one Gateway away but the static route should not be replaced by a
dynamic route, even if the dynamic route is more efficient.
set ip static-routes destination-network net_address
rip-advertise [ splitHorizon | always | never ]
Specifies whether the gateway should use Routing Information Protocol (RIP) broadcasts to advertise to
other Gateways on your network and which mode to use. The default is splitHorizon.
delete ip static-routes destination-network net_address
Deletes a static route. Deleting a static route removes all information associated with that route.
destination-network
destination-network
net_address
net_address netmask netmask
183

Advertisement

Table of Contents
loading

Table of Contents