Table of Contents
Advertisement
PPPoE /PPPoA Settings
You can use the following commands to configure basic settings, port authentication settings, and peer
authentication settings for PPP interfaces on your Motorola Netopia® Gateway.
Configuring Basic PPP Settings.
NOTE:
For the DSL platform you must identify the virtual PPP interface [vccn], a number from 1 to
8.
set ppp module [vccn] option { on | off }
Enables or disables PPP on the Motorola Netopia
set ppp module [vccn] auto-connect { on | off }
Supports manual mode required for some vendors. The default on is not normally changed. If auto-con-
nect is disabled (off), you must manually start/stop a ppp connection.
set ppp module [vccn] mru integer
Specifies the Maximum Receive Unit (MRU) for the PPP interface. The integer argument can be any
number between 128 and 1492 for PPPoE; 1500 otherwise.
set ppp module [vccn] magic-number { on | off }
Enables or disables LCP magic number negotiation.
set ppp module [vccn] protocol-compression { on | off }
Specifies whether you want the Motorola Netopia® Gateway to compress the PPP Protocol field when it
transmits datagrams over the PPP link.
set ppp module [vccn] lcp-echo-requests { on | off }
Specifies whether you want your Motorola Netopia® Gateway to send LCP echo requests. You should
turn off LCP echoing if you do not want the Motorola Netopia® Gateway to drop a PPP link to a nonre-
sponsive peer.
set ppp module [vccn] echo-period integer
Specifies the number of seconds the Motorola Netopia® Gateway should wait before sending another
echo from an LCP echo request. The integer argument can be any number from between 5 and 300
(seconds).
®
Gateway.
187
Advertisement
Table of Contents
