Table of Contents
Advertisement
Operating Instructions
Fig. 6-20. Configuration for Mounting and Laminating With
Thermal Film.
Fig. 6-21. Configuration for Mounting and Laminating With
Pouch Boards.
To mount and overlaminate with thermal film or
pouch boards:
1.
Preheat the top heat pressure roller to the
desired temperature.
2.
Set the speed to 1 fpm (0.3 m).
3.
Set the roller pressure handle to the proper
setting.
4.
Position the item to be laminated on the board.
5.
Start a board into the heat pressure rollers.
Press RUN and guide the item into the rollers.
6.
Press STOP when the last item exits the back of
7.
the laminator.
8.
For thermal film, cut the web and trim out the
board if needed.
56FM
Page 6-15
Advertisement
Table of Contents
